You are here: Experiment Guide > Overview of AFM Operation > Select Experiment

Select Experiment

The Select Experiment dialog allows the user to tell the system what SPM mode they will be working in (the Select Experiment Category panel), choose a subcategory of that mode, such as air or fluid (the Select Experiment Group panel), and a pre-loaded workspace (the Select Experiment panel).

A workspace is a set of scan parameters optimized for a particular imaging mode. NanoScope also allows users to save their own parameter configurations for frequently used, optimized experiments. Although the user will likely choose to 'tweak' a few parameters while scanning, this functionality enables all users to quickly jump to the setup most likely to start giving them good results.

  1. Click Experiment > Select Experiment or the Select Experiment icon in the top left of the NanoScope software window. This opens the Select Experiment window.

NOTE: Modes shown in above are for a Dimension Icon. Some modes are unavailable or optional on the Dimension Icon-PI.
 
  1. In the Select From panel, choose an experiment category by clicking the icon for one of the Imaging Modes.
 
  1. In the Select Experiment Group panel, choose the type of experiment that pertains to your study (e.g. TappingMode in Air).
 
  1. In the Select Experimentpanel, choose either a factory-supplied default experiment (eg. ScanAsyst in Air) or one of your previously saved experiments. This selection will configure the scan parameters within NanoScope with pre-loaded values specific to the experiment type.
 
  1. Click Load Experiment.
HINT: To load the experiment used most recently by the system, a shortcut option is available: click the check box next to "Use previous experiment" then click the Load Experiment button.

Next Steps:

  1. Prepare and Load the Probe Holder
  2. Install the Probe Holder on the SPM Scanner
  3. Identify the Probe
  4. Align the Laser
  5. Adjust the Photodetector
  6. Locate the Tip
  7. Load the sample and Focus on the Sample Surface
  8. If your experiment involves TappingMode, you must nowTune the Cantilever before proceeding to the next step. If you are running a Contact Mode application, continue to Check Initial Scan Parameters.
  9. Engage, Scan, & Withdraw

 

www.bruker.com Bruker Corporation
www.brukerafmprobes.com 112 Robin Hill Rd.
nanoscaleworld.bruker-axs.com/nanoscaleworld/ Santa Barbara, CA 93117
   
  Customer Support: (800) 873-9750
  Copyright 2010, 2011. All Rights Reserved.